Air Pneumatic heat pressing instructions (Powder System)

Created by service Department, Modified on Thu, 9 Feb, 2023 at 7:56 AM by service Department

A picture containing text, clipart 
Description automatically generated


Pneumatic/air heat press is necessary for this application. A high amount of pressure is required to apply the transfer to the substrate or garment. The high amount of pressure ensures that the no-powder DTF transfers into the weave of the textured substrate. Dual silicone pads are recommended in some applications. CobraFlex Printers & are dealers that recommend that you test every product before going into production as each item may have different characteristics. These settings below are a point of reference for application only. 



Product

Temp

Air-Pneumatic Heat Press

Pre-Press 

Press-Transfer

Post-Press

100% Cotton

320 Degrees

140-150 PSI

Warm Platten

5 Seconds

1-2 Seconds

50/50

320 Degrees

140-150 PSI

Warm Platten

5 Seconds

1-2 Seconds

100% Polyester

320 Degrees

140-150 PSI

Warm Platten

3 Seconds

1-2 Seconds

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article