White Keeps Poking Out of Design Towards One Side of the Image

Created by service Department, Modified on Fri, 03 May 2024 at 08:08 AM by Mickey Whitaker

Problem Description: 

The white part of a design keeps poking out towards one side of the image. 


This is an alignment issue with your white layer.  You will need to go into your software and adjust your settings. Usually if it is out of alignment, you will need to add numbers to the white layer and do a few test prints.  

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article